The logic level at that pin can be used to select a particular TMP102 slave device. That is not the purpose of ADD0 - it is a configuration ... ... <看更多>

Macros. I2C Address Flags ... 10-bit address flag More. ... Specifies the address type for the functions ARM_I2C_MasterReceive, ARM_I2C_MasterTransmit and ... ... <看更多>

There is nothing built into I2C to do this, normally slave devices will have some externals pins that can be set to 0 or 1 to toggle a couple of the address ... ... <看更多>

However, you may find that some of the sensors use the same I2C address (especially if it is the same type of device). This will cause data collisions and make ... ... <看更多>

This program can confuse your I2C bus, cause data loss and worse! It will send a I2C read command from address 0x00 to 0x7F. When probing I2C address, the ... ... <看更多>

標題Re: [請益] I2C EEPROM Start address. 時間Mon Sep 4 15:24:56 2017. ※ 引述《vito9580 (vito)》之銘言： : 各位前輩好，最近在研讀EEPROM 24LC16,但有幾點無法 ... ... <看更多>